This Peal Coat WP1A Melting
Pot is a thermostatically controlled, electrically heated tank and
will get the job done just fine for applying strippable seal peal
coating to most screw thread gages. It is pretty much just plug-in
and play. Plug the WP1A Hot Pot into a local power supply, fill
the melting pot with strippable seal peal coating, set the temperature
appropriate for the strippable seal peal coating selected, let the
strippable seal peal coating melt, and you are ready to start protecting
your screw thread gages from rust and mechanical damage.
The WP1A Hot Pot has a fluid capacity of approximately 1 pint (1
pound). The inside diameter is 3.5" with a depth of 3".
The outside size is 5.5" diameter and 6.5" tall. Power
can be supplied in either 115 volts or 220-1 volts. The WP1A is
wired for use in the USA. Figure that the WP1A melting pot weighs
about 5 pounds when packaged for shipment.
Seal Peal Coating Melting Hot Pots are available in multiple sizes
so if this one is too small for your application, just
ask and we can provide alternatives specific to your job.
The manufacturer suggests that melting tanks should be matched
to the size of the items to be coated. The smallest capacity is
selected because excessively large equipment will cause degrading
of the strippable seal peal coating. Using a small tank allows the
strippable seal peal coating material in the tank to be used and
replaced more frequently, thus keeping it fresh.
This pricing is subject to change but is provided to give you a
budgetary number. As of May 27, 2009 the sell price of the WP1A
hot pot was: US$240. The WP1A melting tank is usually in stock with
a 1 week lead-time. Call or e-mail and we will provide an accurate
quotation with current price and lead-time.
Initial Posting: May 27, 2009
Revised:
Comments about this page may be sent to Wayne at:office@gagecrib.com
Gage Crib Worldwide, Inc.
6701 Old 28th St SE, Suite B
Grand Rapids, MI 49546-6937
Phone: 001-616-954-6581 • Fax: 001-616-954-6583 CONTACT FORMS & INFO